Banner Board Sensor Conversion Kit

The original manufacture used two different sensors over the years. Both of which were inferior and very expensive. First was a Cutler Hammer inferred photo eye that struggled to pick up dark lumber or mold. Secondly a 30mm photo eye shaped like a proximity sensor was used. This sensor used a red light that picked up dark lumber much better than the inferred sensor, but the cost increased significantly. The Banner Conversion Kit averages about half what the competitor’s sensor alone costs. The kit comes with all wiring, bracketry, and hardware for installation.

Item                       PN            Description

100010                  2             Screw, Pan Head 6-32 X 1

100053                 2             Screw, Socket Head Cap, 10-32 X 1

400031                 1              Sensor, Banner Board, Photo Eye

400222                1              Cable, Board Sensor, Turk

1001941                 1             Mount, Nut Plate, Board Sensor

700408                1             Mount, Banner Board Sensor